SALE
SIEMENS LME11.230C2 Burner Controller

SIEMENS LME11.230C2 Burner Controller

Orijinal fiyat: $133.50.Şu andaki fiyat: $121.30.

LME are used for the startup and supervision of 1- or 2-stage gas burners or gas burners in intermittent operation. Flame supervision takes place via an ionization probe or a QRA2 / QRA2(1) / QRA2(2) / QRA2.9 / QRA4.U / QRA10.C UV flame detector with AGQ3.xA27 ancillary unit for forced draft gas burners, or, in the case of blue-burning flames, with a QRC1 blue-flame detector. In terms of housing dimensions, the LME are identical with the burner control LGB and LMG burner controls (refer to Type summary).

  • Applications in accordance with EN 676: Forced draft burner for gaseous fuels
  • Type-tested and approved in accordance with DIN EN 298
  • Undervoltage detection
  • Air pressure supervision with functional check of the air pressure switch during startup and operation (depending on the respective type)
  • Electrical remote reset facility
  • Multicolor indication of fault status and operational status messages
  • Limitation of restarts
  • Accurate control sequence thanks to digital signal handling
  • Controlled intermittent operation after a maximum 24 hours of continuous operation
  • Model: LME11.230C2
  • Operation: Single-stage burner control
  • Operating Voltage: 220V AC
  • Safety Time (TSA): 3 seconds
  • Pre-purge Time (t1): 20 seconds
Kategoriler: , Marka:

The SIEMENS LME Burner Controller serves as the central brain for modern industrial and commercial combustion systems. By replacing traditional electromechanical programmers with advanced microprocessor technology, the LME series delivers precise, repeatable timing sequences for pre-purging, ignition, and flame stabilization, minimizing fuel waste and mechanical wear during start-up cycles.

Safety is paramount in the LME’s architecture. The unit constantly monitors grid stability; if supply voltage drops below predefined safety thresholds, the controller safely aborts the ignition sequence and prevents a restart until nominal voltage is restored. Furthermore, it conducts an automated functional check of the air pressure switch before every start, eliminating the risk of combustion without adequate air supply.

  • Model: LME11.230C2
  • Operation: Single-stage burner control
  • Operating Voltage: 220V AC
  • Safety Time (TSA): 3 seconds
  • Pre-purge Time (t1): 20 seconds

Değerlendirmeler

Henüz değerlendirme yapılmadı.

“SIEMENS LME11.230C2 Burner Controller” için yorum yapan ilk kişi siz olun

E-posta adresiniz yayınlanmayacak. Gerekli alanlar * ile işaretlenmişlerdir

İlgili ürünler